[Home ] [Archive]   [ فارسی ]  
:: Volume 21 - ::
ICOP & ICPET 2015, 21 - : 1429-1432 Back to browse issues page
Design and fabrication a fiber optic pressure sensor based on diaphragm fabry-Perot
Azam Layeghi , Mohsen Jamshidi Seresht , Hesamodin Khashei , Hamid Latifi * 1
Abstract:   (1875 Views)
This paper presents the fiber pressure sensor based on Fabry-Perote interferometry. The design and fabrication of the sensor are based on MEMS technique. The polymer diaphragm analysis was done theoretically. The pressure sensor response is approximately linear in the range from 0 to 15 Kpa at room temperature. For sensor with 1.1mm and 3.1 mm diaphragm thickness, the sensitivities are -644 nm/Kpa and -417 nm/Kpa with limit of detection of 4×10-3 Pa and 6×10-3Pa, respectively. Also, the young’s modulus and resonance frequency of diaphragm was calculated according to experimental results. The simple fabrication, small size, and linear response make the sensor suitable for many industrial applications.
Keywords: Diaphragm, Fabry-Perot, Fiber optic, Pressure sensor.
Full-Text [PDF 679 kb]   (2119 Downloads)    
Type of Study: Research | Subject: Special
Send email to the article author

Add your comments about this article
Your username or Email:

CAPTCHA code


XML   Persian Abstract   Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Layeghi A, Jamshidi Seresht M, Khashei H, Latifi H. Design and fabrication a fiber optic pressure sensor based on diaphragm fabry-Perot. ICOP & ICPET. 2015; 21 :1429-1432
URL: http://opsi.ir/article-1-739-en.html


Volume 21 - Back to browse issues page
انجمن اپتیک و فوتونیک ایران Optics and Photonics Society of Iran
Persian site map - English site map - Created in 0.05 seconds with 30 queries by YEKTAWEB 3781