[Home ] [Archive]   [ فارسی ]  
:: Volume 20 - ::
ICOP & ICPET 2014, 20 - : 1129-1132 Back to browse issues page
Design and fabrication of CW low signal Ytterbium doped fiber amplifier
Nooshin Shatery Nejad * 1, Mohamad Javad Hekmat , Hamid Reza Zangeneh
Abstract:   (3260 Views)
In this paper, we have presented the theoretical and experimental models to design and fabricate CW YDDC fiber amplifier in weak input signals.First of all by using RP fiber power software, , the effects of changing power of signal and pump on the ASE power, which is one of the greatest sources of noise in amplifiers, have been simulated. Second, the schematics of amplifier has been designed and fabricated. We have assessed two signal diode lasers one with 0.5 nm line width and the other one with 30 MHz then we compared them with each other. Finally by choosing appropriate elements we have obtained narrow line width signal, the results showed amplification of almost 80 W as an output signal from 200mW input signal power and the rate efficiency was about 70% .
Keywords: ASE effect, CW fiber amplifier, Double clad fiber, Narrow line width, Ytterbium
Full-Text [PDF 846 kb]   (969 Downloads)    
Type of Study: Research | Subject: Special
Send email to the article author

Add your comments about this article
Your username or Email:

CAPTCHA code


XML   Persian Abstract   Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Shatery Nejad N, Hekmat M J, Zangeneh H R. Design and fabrication of CW low signal Ytterbium doped fiber amplifier. ICOP & ICPET. 2014; 20 :1129-1132
URL: http://opsi.ir/article-1-439-en.html


Volume 20 - Back to browse issues page
انجمن اپتیک و فوتونیک ایران Optics and Photonics Society of Iran
Persian site map - English site map - Created in 0.05 seconds with 30 queries by YEKTAWEB 3781