[Home ] [Archive]   [ فارسی ]  
:: Volume 23 - ::
ICOP & ICPET 2017, 23 - : 889-892 Back to browse issues page
Design and fabrication of cube beam splitter for visible range and 1550nm wavelength
Mehdi Mardiha * 1, Javad Shah mohammadi 1, Alireza Firoozifar 2, Mohammad mahmood Varpaei 1
1- isfahan university
2- isfahan universityc
Abstract:   (839 Views)

In this research Design and fabrication of cube beam splitter, has been reported. Designing and simulation performed with Essential Macleod software before deposition. Deposition was performed using physical vapor deposition with electron gun. Refractive indices and optimized deposition conditions of materials achieved with single layer deposition. 21 layers thin film stack deposited on hypotenuse of prism. Then prisms cemented to each other and transmission spectra of beam splitter measured using a dual-beam spectrophotometer. Finally transmission spectrum showed 92% for 1550 wavelength and 30% for visible wavelength rang.

Keywords: Cube beam splitter, Deposition, Vacuum chamber.
Full-Text [PDF 352 kb]   (240 Downloads)    
Type of Study: Research | Subject: Special
Add your comments about this article
Your username or Email:

CAPTCHA code


XML   Persian Abstract   Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

mardiha M, shah mohammadi J, firoozifar A, Varpaei M M. Design and fabrication of cube beam splitter for visible range and 1550nm wavelength. ICOP & ICPET. 2017; 23 :889-892
URL: http://opsi.ir/article-1-1337-en.html


Volume 23 - Back to browse issues page
انجمن اپتیک و فوتونیک ایران Optics and Photonics Society of Iran
Persian site map - English site map - Created in 0.05 seconds with 30 queries by YEKTAWEB 3781